fbekholden.com

G'day All.

Proberley this same ? has been asked before, But are the black pieces on the handles on the window regulators fixed or are they supposed to spin (black piece on the chrome) Mine are all tight and I have seen lots of others that do not turn also, but at the Car show at Kembla Grange I noticed some did spin quite freely, Also does the inner door handle position sit level (horizontal)or is it projected upward to the 2 o'clock position.

Now while I'm at it, does the boot rubber have a slight feathered flap that projects to the inside of the boot, or should the seal be a square section in profile. The reason I'm asking is that my seal is a Feather type and when you close the bootlid the feathered edge of the seal actually forces it's way out on the bottom edge of the boot, Hense doesn't seal and looks crap.

Regards John

Hmm, Interesting!

I haven't paid that much attention to the winder knobs (must check) Understand though these handles are 100% Chevrolet and were used in many model Holden's. Maybe there was a change in design at some stage with the release of the knob?

The door handles are flat and level in early Holden's and that would be pointing at 9 O'Clock on a clock face open end towards the dash board.

Regards, Smooth

on the van 1 spins freely 1 doesn't haveing owned hundreds mostly they haven't spun

they are all supposed to spin.

those that dont spin are corroded on the spindle - if you force them then they will rotate.

Just pulled 3 (NOS) out of there boxes. None of these spin freely. Although can be forced to turn.

Regards, Smooth

None of mine spin, and there far from NOS ,
Trev

g'day john
i've got a sh#t load, and none of em spin

cheers ray

My old ones AND new ones spin
I like them to spin...

One out four spins on mine, I have others but haven't checked them yet...

rofl, don't go out of your way there mate!

Regards, Smooth

All mine spin,or is that my head,maybe I should open the garage door before warming the car!

smooth wrote:rofl, don't go out of your way there mate!

Regards, Smooth

You'd know why I said I haven't checked them yet if you saw my other shed! Can't bloody move in there, plus I've forgotten where I put them

Devilrod wrote:

smooth wrote:rofl, don't go out of your way there mate!

Regards, Smooth

You'd know why I said I haven't checked them yet if you saw my other shed! Can't bloody move in there, plus I've forgotten where I put them

I figured you only checked the drivers door on your EK?

Regards, Smooth

Nah not quite that lazy! But I did do it while driving home in peak hour traffic, must have looked funny...