Looking for a lower firewall and transmission hump

rickbantam · Post by **rickbantam** » Sat Sep 26, 2015 6:59 pm

Hi to everyone,

I have an EK sedan which someone in the past has removed the standard EK lower firewall (from the seam down to the point where the floor and firewall meets) and transmission hump in preparation for an updated running gear, I would like to have it restored to a grey motor gearbox setup. I am also after a cut of the rear of a sedan mainly the curved section around the fuel filler. If any of you out there in Perth/W.A. have a donor car or know of where I can find one to cut out these sections I would appreciate it, I'm willing to part with cash and/or if anyone is interested in the two spare boot lids I have I can throw those in as bargaining chips.

Thanks for reading and let me know if you can help

Todd

Post by **Blacky** » Sat Sep 26, 2015 8:57 pm

Todd, you know where to come

. I have a firewall and a sedan donor you can cut your bits out of

rickbantam · Post by **rickbantam** » Sat Sep 26, 2015 11:19 pm

Ha the famous EKmart

Blacky that would be fantastic, let me know when that is convenient for you I appreciate the offer let me know if we can trade parts/cash

Todd

rickbantam · Post by **rickbantam** » Fri Oct 23, 2015 11:34 pm

Hey all posted a few weeks ago but I've been all over the country so here goes again I need a donor cut off a lower firewall and tranny hump as you can see by the pic my sedan has been set up for a v8 but I would rather it be stock if any one can help with a donation of this I'd appreciate it. I'm on a tight timeline as I will be moving to Melbourne in mid December for 2 yrs but plan to be back in 2018 with an EK painted with mint body work (my project while I'm there)

you can see in the picture what I'm after from the seam down to where the floor pans go up on the angle and also the tranny hump to where the front seat sits. Drop me a line if you can help I'm willing to pay for the bits

Todd

Post by **Blacky** » Sat Oct 24, 2015 9:56 am

its still here Todd......

rickbantam · Post by **rickbantam** » Sun Oct 25, 2015 10:08 pm

Blacky

Sorry mate been all over the shop the last couple of weeks and haven't really read the replies - actually I think I'm in WA at the moment Lol, hey if its ok can I come up on Saturday morning (31 Oct) to do some cutting, let me know if thats ok as I'm keen to get this little job done

Todd

Post by **Blacky** » Sun Oct 25, 2015 11:01 pm

If I am home , will find out later in the week if I am going bush again on Friday......

rickbantam · Post by **rickbantam** » Mon Oct 26, 2015 4:33 pm

Blacky,

No props at all mate I'm free every weekend till mid december so I'll fit in with you

Todd

rickbantam · Post by **rickbantam** » Thu Nov 05, 2015 12:25 am

Blacky,

Just let me know a date mate as I'm available most weekends

Todd

Post by **Blacky** » Thu Nov 05, 2015 7:32 am

Todd, I SHOULD be flying home tomorrow, I will let you know.

Post by **Blacky** » Sat Nov 07, 2015 5:37 pm

Am at home mate.

rickbantam · Post by **rickbantam** » Mon Nov 09, 2015 11:49 pm

Blacky

If your up to a visit this weekend let me know have cash and bits to swap and eternal gratitude as well

Todd

fbekholden.com