fbekholden.com

I Recently purchased the Rare Spares HR crossmember exchange with the EK outrigger fitted.
I also bought the R.S. set of new bushes to bolt it in.
The 4 main bolts and bushes fitted up pretty easy. I have about a 7 -8mm gap between Xmember and sub-frame, but the front outrigger with the square bush and saddle bracket is about 15-20mm from the underside of the sub-frame under the radiator.?

Have I done something wrong here. Any help appreciated.

Think from memory you need the rubber rare spares sell too.

Yeah. Sorry said bushes but did buy the rare spares rubber kit.
Should I just bolt the 4 main bolts lightly then fit the
Outrigger firm then just crank the 4 bolts tight ? Worried it will
Only Distorts the rubber. It's like the outrigger angle
Is welded on low ?