Page 24 of 64

Re: Red Rattler Revamp

Posted: Fri Jan 07, 2022 8:51 pm
by Blacky
Cut down a 1/2” UNF bolt in my hand held milling machine and screwed it in there then gave it a couple of whacks with a centre punch to make sure it doesn’t come loose
Image
Image
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Fri Jan 07, 2022 8:53 pm
by Blacky
Cleaned up the casting dags inside it ,Then screwed itImage
all together and gave it a coat of jam
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Sat Jan 08, 2022 10:17 am
by EK283
Nice work Blacky,

Your obviously going to pick up the oil from the rear of the sump ?

The red engine loves to fill the rocker cover up so a drain from the rear of the cover back to the sump is also a good idea if you are going to ring its neck.

Greg

Re: Red Rattler Revamp

Posted: Sat Jan 08, 2022 11:19 am
by Blacky
Its supercharged mate so not going for big revs, 6k maximum I would think - it will run out of cam beyond that .....

Re: Red Rattler Revamp

Posted: Sat Jan 08, 2022 11:26 pm
by Blacky
Got a bit more done today , not as much as I hoped - had a few distractions helping out neighbours , all 3 of them with various issues ImageImageImageImage
Rebuilt the pedal box , got the oil pump in , motor bolted back down , cleaned up the blower drive pulley, changed out the alternator plus a couple of other little jobs , oh and installed a power point on the hoist, got sick of the nearest outlet being 6 feet awayImageImage
Image
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Sun Jan 09, 2022 11:10 pm
by WesternWagon
Getting closer


Sent from my iPad using Tapatalk

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 12:27 am
by Errol62
You are probably on to this but the photo reminded me, I used a spacer from sonic injection on the thermostat lower housing so the rocker cover is easier to get on and off.


FB ute fixer upper, EK van on rotisserie

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 2:06 am
by Blacky
Errol62 wrote: Mon Jan 10, 2022 12:27 am You are probably on to this but the photo reminded me, I used a spacer from sonic injection on the thermostat lower housing so the rocker cover is easier to get on and off.


FB ute fixer upper, EK van on rotisserie
Yeah , the blower front support bracket goes on there and acts as a spacer, got 2 gaskets on the list of bits to pick up tomorrow

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 2:23 am
by Blacky
Worked on sorting out the steering and pedal box today , got a couple of hours in this morning then took the bride out to lunch in Fremantle and came home and mowed the lawn
Looks like it’s going to work, will probably buzz the flange off the subframe to give the steering shaft some more clearance
Image
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 2:26 am
by Blacky
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 2:29 am
by Blacky
Then it was off to Freo for fish and chips
Image
Image
Image


Sent from my iPhone using Tapatalk

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 7:48 am
by Errol62
Took her out AND mowed the lawn. Over achiever!


FB ute fixer upper, EK van on rotisserie

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 7:57 am
by Brett027
That's a great photo of you both Blacky. Good use of time to relax and catch up over a tasty meal and cold drink.

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 7:46 pm
by FbSTDwagon
Good to see some serious progress happening!

Re: Red Rattler Revamp

Posted: Mon Jan 10, 2022 8:15 pm
by gledge
Looks like we can line up for a race at the nations mate


Sent from my iPhone using Tapatalk