fbekholden.com

Posted: **Thu Sep 16, 2010 12:10 pm**

No, go the zinc anneal , galv is a bugger to weld and a bugger to get paint to stick to , just go to your local sheety shop and get an off cut the size you need .

Posted: **Thu Sep 16, 2010 12:56 pm**

No worries, thanks Rusty- I have a sheet of 1.5mm Zinc ordered, about 75 bucks

Posted: **Fri Sep 17, 2010 8:50 am**

DOLLER wrote:Is it ok to use Gal sheet?

Gal is a bit of a bugger to weld and gives off fumes that will make you crook - better off with zinc anneal.

fbekholden.com

what guage steel for repairs

Re: what guage steel for repairs

Re: what guage steel for repairs

Re: what guage steel for repairs