eh outrigger

space ace · Post by **space ace** » Tue Dec 15, 2009 8:21 pm

Hi all does anyone know if hr disk brake crossmember fitted with EH outrigger will fit EK obviously will have to drill holes for front engine mount
Pete

Devilrod · Post by **Devilrod** » Tue Dec 15, 2009 9:51 pm

No idea, I'd personally fit an EK outrigger. gaurranteed hassle free.

ek61 · Post by **ek61** » Tue Dec 15, 2009 10:25 pm

eh out rigger is the same but dont think they have the holes 4 front engine mount if using a grey

easy enough to drill out 2 suit though

space ace · Post by **space ace** » Wed Dec 16, 2009 7:03 am

Thanks for the info, the hr front i picked up came off an eh so I wasn't sure on the outrigger

Pete

FB MAD · Post by **FB MAD** » Wed Dec 16, 2009 10:06 am

I think ?? Reddo ?? on the forum here fitted a HR front end with an EH outrigger somewhere back on one of his cars and all he had to do ( using a grey mtor still ) was to drill the two front engine mount holes in the EH outrigger for the grey.

FCOV6 · Post by **FCOV6** » Sun Dec 20, 2009 9:15 am

I thought all the grey fronts used a front outrigger that had a big recess where the motor bolts ?

FB MAD · Post by **FB MAD** » Sun Dec 20, 2009 11:36 am

Not really a big recess but an area of the crossmember outrigger with two bolt holes for the front engine mount to bolt through.

EH's had the red so therefore didn't have the bolt holes in the front outrigger to mount the grey's front engine mount that the previous model EJ and earlier had.

As far as I'm aware the EH outrigger is essentially the same at least down to FB with only difference being the bolt holes for grey fitment.