HR front end

quick finking · Post by **quick finking** » Sun Sep 21, 2008 6:58 pm

Hey i have a EK ute with a HR front end,
i was wondering how i would go about lowering it 2-3 inches.
any help will be appreciated.

DeadSled · Post by **DeadSled** » Sun Sep 21, 2008 7:03 pm

Good to see you made it over here man.

As said on the thread on Boost.. Lowered Springs (King Springs) would be the way to go as with any car for the front.. and lowering blocks or reset leafs for the rear.

Unless you wana go all out.. C notches, bags, four links ect ect..

mrs ratbox · Post by **mrs ratbox** » Sun Sep 21, 2008 8:01 pm

only thing with springs is you might get 2" i don't think you'll get 3"
pull yor springs out cut 1 1/2 - 1 3/4 coils off should do the trick

quick finking · Post by **quick finking** » Sun Sep 21, 2008 8:02 pm

is that what you have done?
im kinda looking for the cheapest possible solution

mrs ratbox · Post by **mrs ratbox** » Sun Sep 21, 2008 8:36 pm

it's not really reckomended

BUT with over 500 cars under my belt most of which were lowered with this method i'm still here to tell the story so can't be that bad

quick finking · Post by **quick finking** » Sun Sep 21, 2008 8:37 pm

mmmk, it sounds the easiest/cheapest way to go so i will give it a go,
if it fails i will go buy some new king springs as deadsled mentioned before

hammondo · Post by **hammondo** » Sun Nov 16, 2008 8:07 pm

ratbox wrote:with over 500 cars under my belt

Holy Moly

mrs ratbox · Post by **mrs ratbox** » Sun Nov 16, 2008 9:59 pm

hammondo WELL over 500

not all built or modified a great deal but most touched in some way by me, very few just bought and drove

Finny · Post by **Finny** » Mon Nov 17, 2008 11:12 am

Hey Rat, can you list them out for everyone ?

Just vealous