wiper base fitment

Malcolm · Post by **Malcolm** » Sun Apr 06, 2008 9:43 pm

Hey all,

Does anyone have a close up picky they could show me as to how the windscreen wiper base sits in relation to the windscreen mould

Mal

mrs ratbox · Post by **mrs ratbox** » Mon Apr 07, 2008 9:53 am

are you talking about the D shaped chrome washer/spacer bit?

Malcolm · Post by **Malcolm** » Mon Apr 07, 2008 1:09 pm

Yeh thats it

mrs ratbox · Post by **mrs ratbox** » Mon Apr 07, 2008 7:45 pm

don't have a pic but what is the problem

Craig · Post by **Craig** » Mon Apr 07, 2008 7:56 pm

Im uploading a pic at the moment mate

Craig · Post by **Craig** » Mon Apr 07, 2008 7:57 pm

hope this helps

rosco · Post by **rosco** » Mon Apr 07, 2008 9:15 pm

Hi Malcolm,
from memory, the posts are "keyed" into the holes into the firewall.

Because this mount passes through into the cabin - make sure you fit suitable neoprene/rubber gaskets around those posts......
I believe I used a smearing of butyl-mastic on the firewall side of my gaskets...

frats,
Rosco

Malcolm · Post by **Malcolm** » Mon Apr 07, 2008 10:23 pm

Thanks guys,

Mine is the same as the picture but it just doesn't look right. As the mould goes over the top of the wiper block it seams to sit up in that area compared to the rest of the mould along the bottom of the screen.