Ethanol fuels

If it doesn't fit below then post here and see if another FB EK fanatic can help you out.

Moderators: reidy, Blacky

Post Reply
Sigs
Posts: 70
Joined: Fri Oct 06, 2006 9:47 am
State: NOT ENTERED
Location: Wollongong

Ethanol fuels

Post by Sigs »

Does anyone know what effect an ethanol type fuel has on the old grey? I acidently put it in my wagon at BP two days ago, drove ok for 1 day but now it won't start.
She is coughing and spluttering but won't fire.
F*#%&ng BP should label there pumps better. I normall put in the Ultimate fuel however this was out so regrettably I put in the fuel which was labelled as 91 unleaded. When I went to pay the lady behind the counter asked me if I had my "ethanol discount card". A few expletives later I continued on my journey.

Mat
mmm, maybe one day :roll:
mrs ratbox

Post by mrs ratbox »

i've never had a problem with the suposedly 10% stuff E10
but i have heard ethanol can eat old rubber and plastics, this may hold the cause to yor problem
karsten
Posts: 613
Joined: Wed Oct 17, 2007 6:31 am
State: NOT ENTERED
Location: bungendore nsw

Post by karsten »

i put that crap in my vr and had no end of trouble syfen the tank and fill her up with rum!!! :shock: ,,, ohh i mean the good gas,,, the rum is for me :lol:
when they start building them like that again i will buy a new car of them
Craig
Posts: 1296
Joined: Thu Jun 14, 2007 5:16 pm
State: NOT ENTERED
Location: Fear and Loathing in Brisvegas

Post by Craig »

I never use BP their normal fuel is crap my work van pings like made on there normal unleaded we have BP fuel card at work so it is generaly all we use occasionaly I have to fill up at other garages and no pinging a mechanic mate refuses to use them as well
Better dead than red

EK, the VN of the 60s
Sigs
Posts: 70
Joined: Fri Oct 06, 2006 9:47 am
State: NOT ENTERED
Location: Wollongong

Post by Sigs »

found the problem, had the wagon at the mechanic the other day so he could use her to check my ute out (major problems, will post for help), anyway the dizzy cap was half off, I can only assume it wasn't put back on properly.
hopefully the rotor will last long enough tommorow for me to get another one....
cheers for the replies
mmm, maybe one day :roll:
Post Reply