Just a picture of something I’m playing with
Re: Just a picture of something I’m playing with
getting rid of the dizzy before next attempt?
Re: Just a picture of something I’m playing with
Oh crap , that doesn't sound promising ........
When you're faced with an unpleasant task that you really don't want to do, sometimes you just have to dig deep down inside and somehow find the patience to wait for someone else to do it for you.
Foundation member #61 of FB/EK Holden club of W.A.
Foundation member #61 of FB/EK Holden club of W.A.
Re: Just a picture of something I’m playing with
The dizzy is only an esp one out of the black carb model so nothing in it...it has crank trigger and msd programable box ( set timing with lap top) but we had problem with the ring gap being to tight, so re hone and new top rings.. try again next week... didn’t even get to rev it over 5500 but only made 220 hp and 228 ftlb still really rich and no timing in it yet see what happens next week I guess
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
Sounds like you'll need a lift to AHD
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Just a picture of something I’m playing with
Might just drive Mick’s wagon Me thinks
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
lucky you found it early - insufficient ring gap can get awful expensive
When you're faced with an unpleasant task that you really don't want to do, sometimes you just have to dig deep down inside and somehow find the patience to wait for someone else to do it for you.
Foundation member #61 of FB/EK Holden club of W.A.
Foundation member #61 of FB/EK Holden club of W.A.
Re: Just a picture of something I’m playing with
For sure .. we did a few runs to bed the cam in and then a little pull up to 5500 and went to have a leak test and it was blowing oil out the breather so we hooked a manometer on the breather and did a small run and found a lot of pressure so the head came straight off!!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
I had a bit of a problem with the bonnet hinge hitting my air filter so thanks to some good info from Brodie and Mr Black here we go with the hinge conversion, had to start by getting rid of some holes and getting the mount point straight as I couldn’t live with the crooked mounting
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
Just had to make a few changes
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
Why the extension on the bottom, just to stiffen it up and brace it from sideways movement when the bonnets open ???
When you're faced with an unpleasant task that you really don't want to do, sometimes you just have to dig deep down inside and somehow find the patience to wait for someone else to do it for you.
Foundation member #61 of FB/EK Holden club of W.A.
Foundation member #61 of FB/EK Holden club of W.A.
Re: Just a picture of something I’m playing with
Yeah that’s what I was thinking and sort of makes it look straight as well
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
Just a picture of something I’m playing with
Though I getter pull my finger out and get these bonnet hinges sorted out as the nationals are creeping up on me pretty quick. Considering I have a car with still no engine and no bonnet to hide the fact there is no engine in there
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Just a picture of something I’m playing with
Sent from my iPhone using Tapatalk
Re: Just a picture of something I’m playing with
Nice work glen
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
getting my FB ute on the road
EK van on rotisserie
EK van on rotisserie
Re: Just a picture of something I’m playing with
Hi Glenn,
What is the master cylinder from ???
Greg
What is the master cylinder from ???
Greg
So many cars so little time!