Clay’s Wedgewood Blue FB Ute

[Errol62]

And another hour
Went whole hog on the stripper on the other door and hopefully speed the process.
These doors are mint. Just have to weld up couple mirror mount holes.


FB ute fixer upper, EK van on rotisserie

[FJWALLY]

They look really clean mate - coming together really nicely - a few hours with the volleys and hammers and a skim of filler and she will be better than it rolled out the shop

Next Question - whats the colour going to be?

[Errol62]

Wedgewood Blue per factory and I’m hoping they won’t need filler Rob.


FB ute fixer upper, EK van on rotisserie

[Errol62]

Not sure what gear i had been on saying no filler but ended up with a smear here and there. Bloody hot today so got in early. Playmates couldn't go surfing till later.
Bit of a lesson don't test the fan spread on the door you're about to paint so now have a small run to sand. Just flashing off first coat but you get the picture. Better get back on it.

Sent from my SM-A705YN using Tapatalk

[Errol62]

Lesson I never seem to learn. Fiddling around putting the body back in the shed dropped both doors on their bottom seams oh fk.

Sent from my SM-A705YN using Tapatalk

[EK283]

Yep I've done the same thing, it really pisses you off !! Oh and will always happen to the perfect undamaged panels !!!!

Greg

[In the Shed]

Big Milestone there Clay,
I can see how you would be pleased when that first coat went on, any colour would be better than looking at the bare metal. You have done well to get a good run at the prep painting given the crap weather we have had of late. Your attention to that tail gate has paid off too, looks a very tidy fit.

Keep them pictures coming

Regards
Stephen

[Errol62]

Cheers Stephen
This guard actually was on the EK van when I got it but turned out go be FB. Remarkably good fit. Few blemishes but. Bought a rares upper rear corner and started reshaping it but I don't like the fit around the cowl vent cover at all.
I had forgotten what a cussing swearing nightmare it is trying to get the bolts in adjacent the door edge. Final fitting will be interesting.

Sent from my SM-A705YN using Tapatalk

[Errol62]

Pretty poor really

Sent from my SM-A705YN using Tapatalk

[Errol62]

Trimmed up the patch

Sent from my SM-A705YN using Tapatalk

[Errol62]

Ready for the morning. Just the one tonight not nine like last night dear.

Sent from my SM-A705YN using Tapatalk

[Errol62]

Trying to be patient and take my time so as to avoid warpage. Cleco clamps, 1mm disc and peen hammer.

Sent from my SM-A705YN using Tapatalk

[Errol62]

Starting to come together

Sent from my SM-A705YN using Tapatalk

[Errol62]

Passenger side guard top corner I used a piece cut from the driver side repair. Came out a bit better. The gap to plenum cover is a bit narrow in a couple of spots so bit of hammering. Still better than too much gap u think. This side I welded off the car using copious cooling with wet rag. Being a bit slack drying the panel, I got a small boot from the panel when I started welding again. Making sure to dry thoroughly now. I didn't bother fitting the door this time. Original panels this side.

Sent from my SM-A705YN using Tapatalk

[FireKraka]

Clay you are doing a great job mate and getting real close now to getting colour on.
Cheers
Neil