Had some time tonight to put the diff and brakes back together
Im still missing some wheel cylinder push rods can slot them in when i find some
She went together quite well after some homebrew longnecks
The three bottom bolts are they ment to have copper washers on them are they ment to be studs with nuts or all bolts?
would any one know, the bolts in the torry housing were way to long for the center i put in
The C is from the torry diff and the W is from the fb diff but ive mixed up the little rods and not 100% on which is which i tried the longer one but the drums seems a little loose and the short one was a tight fit i presume it should be tight
hence the spring tention c or w clip anyone have any they could measure.
torry hand brake to fb.
For the under floor hand brake pivot arm as the trimatic is now wider and longer than the oem box the arm and bracket needs to be moved more from the center over to the drivers side rather than moving out the pully hand brake wire wheels to match the bracket being moved im going to flip the pivot bracket over so the mount will be closer to the drivers sill panel and the wire to the pullys / firewall will stay in the same location.
The Fb hand brake cable being one piece im hoping as i relocate hand brake cable 180 bracket more to the the rhs of the car as the driver side of the hand brake cable gets shorter it will make up length on the lhs of the cable.
cheers