Getting started - advice sought...

If it doesn't fit below then post here and see if another FB EK fanatic can help you out.

Moderators: reidy, Blacky

Post Reply
Trev
Posts: 7897
Joined: Thu Apr 15, 2004 6:43 pm
State: NOT ENTERED
Location: Wonthaggi

Re: Getting started - advice sought...

Post by Trev »

Yes but you might get shot there :shock: :lol:
[img]http://i47.photobucket.com/albums/f177/trevwood/WOOFTOsmall.jpg[/img]
Woofto Car Club Member No3
Top
User avatar
Devilrod
Posts: 7394
Joined: Fri Apr 30, 2004 12:55 pm
State: VIC
Location: Beaconsfield, Vic

Post by Devilrod »

Good one Trev!

If you're looking for a panel shop closer to the city the trimmer Trev uses is further out again! He's in Cranbourne.... :mrgreen:
Top
RollinLow
Posts: 132
Joined: Sun Feb 07, 2010 7:19 pm
State: NOT ENTERED
Location: Melbourne

Re: Getting started - advice sought...

Post by RollinLow »

Tim at Sew fine auto interiors is a pretty good trimmer that does reasonable prices,

These are his details:

Timothy Parsons

Sew Fine Auto Interiors
82a Camms rd
Cranbourne 3977
Ph:(03) 5998 4401

tell him Chris from Directed sent you! :thumbsup:
Top
User avatar
WayneXG95
Posts: 2565
Joined: Wed Sep 07, 2011 9:42 am
State: NSW
Location: Sydney

Re:

Post by WayneXG95 »

Devilrod wrote:Sounds like it'll turn into a ground up rebuild if you're not careful :shock: :lol: :lol: They always do.....
Now there happens to be a true statement.... :lol:

Cheers
Wayne Chambers
President
FB EK Holden Car Club of N.S.W
Top
Post Reply

Return to “General sharing advice and experience”