rear bumper

[basic.green]

hi what do you guys put between the rear bumper and the rear 1/4 panels on the sides
any help

[EKjimmy]

from the 3 EK's i've played with, they all had rubber spacers between the quarter and bumper, which the bolts go through the middle of. I think they're about a 1/2 inch thick just with a hole in the centre for the bolt. I'm sure clark rubber should have something you can use for that

[basic.green]

thanks mate
i rang rares no good so i will go to clarks

[(AUST)Mod]

The ones in my car look just like the rubber donuts which come with sock absorbers to go between the pin and the body on the back of FBEK sedans.

HTH

A.

[artyfartymarty]

mine has steel saddles front and back

[cramfest]

you could probably get away with a sway bar post rubber they are about the same thickness

[artyfartymarty]

you could go to a a boat trailer shop and check out their polyurethane rollers, various sizes, some are tapered so you ccould ut them in half or just get the ones that have consistent diameter and cut to lentgh....already has a hole in the centre and comes in a variety of colours, i've seen black, blue red and yellow, Not sure if you'll get lime green though

[Thommo]

Or go to the hardware shop and get some old fashion doorstops,
they might do the trick as well.

[stinky]

Or go to the hardware shop and get some old fashion doorstops,
they might do the trick as well.

They do the job a treat, that's what I used on my car.