After-market pushrods???

If it doesn't fit below then post here and see if another FB EK fanatic can help you out.

Moderators: reidy, Blacky

Post Reply
FB search
Posts: 60
Joined: Thu Apr 26, 2007 5:53 pm
State: NOT ENTERED
Location: Brisbane

After-market pushrods???

Post by FB search »

Hi there peoples,

My newly acquired 'warm' grey motor is bending push rods. :shock: :roll:

Has anyone got any suggestions?

I was wondering if there are any after-market pushrods that are perhaps
thicker or made of stronger stuff?

The motor is far from wild. It has a mild cam and a 132 head on a 138 block.
It has extraction and induction goodies but surely they wont cause pushrods
to bend will they?

Kindly
Dominic
The search continues...
Top
FB search
Posts: 60
Joined: Thu Apr 26, 2007 5:53 pm
State: NOT ENTERED
Location: Brisbane

Post by FB search »

Cheers SunnyTim,

I'll check the clearances tomorrow.
The search continues...
Top
User avatar
Sammy
Posts: 664
Joined: Mon Jun 26, 2006 3:06 pm
State: NOT ENTERED
Location: Tenambit, NSW.
Contact:
Contact Sammy

Post by Sammy »

might want to check and make sure the valve springs arn't binding up, this will cause your issue.
Regards,

Sammy.

http://www.oldholdens.com
Top
Post Reply

Return to “General sharing advice and experience”