I'm excited

[gazrat]

all packed and ready to go just got to work out which one to sell

will have a spot on the way home so if any one has any trouble let us know

[parisian62]

just got to work out which one to sell

that would be a very hard decision gaz...can the truck go?

c u there.

Stewart

[mrs ratbox]

well i know tim is half way there passed between narrabri and moree

[Cal]

Glad you made it home well, Tim.

What do you men by "no more electrical fires"..............did you have some sort of drama?

[Cal]

Glad it wasn't anything major..........F******** FB's

Presuming no one did a timing gear this year?

[vmx-mxr]

Timing gears ???

Check out http://www.fbekholden.com/forum/viewtop ... 21&t=11159 Glad to read it didn't happen on the way and you weren't too inconvenienced Dave!

To quote Cal - "Glad it wasn't anything major..........F******** FB's " - Lol!

Note to self when checking over the Eee Kay ute's engine - fit alloy or steel timing gear !!!

Dave Mac

[Thommo]

Note to self when checking over the Eee Kay ute's engine - fit alloy or steel timing gear !!!
Dave Mac

Fit a steel timing gear, not the alloy one.

[vmx-mxr]

OK - Sounds good.

We'll let Dave tell us where he gets his eh?

I think I read somewhere that there had been problems with the alloy ones and I gather by your suggestion that is the case?

Thanks

Dave Mac

[Stygian]

I think I read somewhere that there had been problems with the alloy ones and I gather by your suggestion that is the case?

Yep, the camshaft can chew the centre out of the alloy gear.

Andrew

[vmx-mxr]

Thanks for that Andrew - Steel it is then !

I'll kick off a new thread lest this one be buggered up by going too far off track.

Dave Mac

[Craig]

Yes I had an electrical short .
Tim

no good dead goes unpunished mate

I'll swap you a Lisa's EK wagon for that dirty FB she wouldnt be happy but we have been married for 16years so she is used to not being happy