Question on Dissy O rings?

If it doesn't fit below then post here and see if another FB EK fanatic can help you out.

Moderators: reidy, Blacky

Post Reply
User avatar
WayneXG95
Posts: 2565
Joined: Wed Sep 07, 2011 9:42 am
State: NSW
Location: Sydney

Question on Dissy O rings?

Post by WayneXG95 »

What is everyone using to replace the O ring in the distrubitor?

Image
Wayne Chambers
President
FB EK Holden Car Club of N.S.W
Top
parisian62
Posts: 3996
Joined: Wed May 11, 2005 2:19 pm
State: NSW
Location: Sydney
Contact:
Contact parisian62

Re: Question on Dissy O rings?

Post by parisian62 »

Go to CBC Bearings or Pirtek...
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Top
User avatar
WayneXG95
Posts: 2565
Joined: Wed Sep 07, 2011 9:42 am
State: NSW
Location: Sydney

Re: Question on Dissy O rings?

Post by WayneXG95 »

Which CBC did u use Stewart?
Wayne Chambers
President
FB EK Holden Car Club of N.S.W
Top
parisian62
Posts: 3996
Joined: Wed May 11, 2005 2:19 pm
State: NSW
Location: Sydney
Contact:
Contact parisian62

Re: Question on Dissy O rings?

Post by parisian62 »

The one at 1/63 Marigold Street Milperra / Revesby.
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Top
User avatar
WayneXG95
Posts: 2565
Joined: Wed Sep 07, 2011 9:42 am
State: NSW
Location: Sydney

Re: Question on Dissy O rings?

Post by WayneXG95 »

Ta, dose it leak?
Wayne Chambers
President
FB EK Holden Car Club of N.S.W
Top
parisian62
Posts: 3996
Joined: Wed May 11, 2005 2:19 pm
State: NSW
Location: Sydney
Contact:
Contact parisian62

Re: Question on Dissy O rings?

Post by parisian62 »

Dry as a bone. I took a dizzy with me that had an O ring still on it so they had something to measure off.
Feelin free in a '61 FB.
Member of FB-EK Holden Car Club Of NSW Inc.
Check out the Rebuild of Old Timer
Top
Post Reply

Return to “General sharing advice and experience”