NASCO/dealer fitting instructions

Need something for your daily driver or to finish off that project?

Moderators: reidy, Blacky

Post Reply
User avatar
Harv
Posts: 5097
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

NASCO/dealer fitting instructions

Post by Harv »

The FB I recently bought has a number of accessories, most of which appear to be either NASCO or dealer fitted:

a) Coolaride sunvisor,
b) Warmaride heater,
c) scratch plates,
d) locking petrol cap,
e) Wibroc mudguard mirror,
f) engine oil filter (not sure if it is a FRAM or otherwise),
g) His Master's Voice radio and speaker,
h) Staput gear lever lock,
i) brake booster,
j) vacuum windscreen washers (looking to buy a set... heres hoping).

Some of the accessories are fitted, but most are not. Some of them also need a good clean-up/respray. To help me learn more about them (and to avoid me buggering them up :oops: ), I would like to get hold of copies of the original fitting instructions/sheets or brochures. Is anyone willing to pass on scanned/photocopied sheets please? If it helps, I am a NSW club member - I know the FE/FC forum will only pass accessory sheets on to (FE/FC) club members.

Regards (and thanks),
Andrew
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
User avatar
Harv
Posts: 5097
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Post by Harv »

PM sent - thanks Tim!
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
User avatar
Harv
Posts: 5097
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Post by Harv »

Tim, did the PM get through?
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
Post Reply