fbekholden.com

Hi guys, rare spares used to make a rear 1/4 rust repair section,i brought one years ago but unfortunatley they dont make them any more does anyone know if any one else does something similar.I have the left hand side but need the right.

Doesn't surprise me they don't make them anymore

Try this bloke

http://cgi.ebay.com.au/FE-FC-FB-EK-HOLD ... 51906429b9

His name is Craig Vayne in QLD and he makes a lot of repro panel stuff.He said to me a few years ago that he can pretty much make anything as long as he has a template to go from.

Send him a message via ebay with what you need.

thanks fb mad,I have to give him a call to get some sill panels so i will ask him then

Hi Steve,

I tried Craig a few months back and he said he didn't make them.

Stewart

Depending on how bad, you could get the peice rolled up or try here
https://vault2.secured-url.com/ShopSecu ... ake=HOLDEN
R181 HOLDEN FC-FE-FB-EK Rear 1/4 Rust Panels - Left $46.46
R182 HOLDEN FC-FE-FB-EK Rear 1/4 Rust Panels - Right $46.46
or
http://www.retrorods.net.au/rustrepairs.html
Trade prices
R181 HOLDEN FC-FE-FB-EK Rear 1/4 Rust Panels - Left $38.00
R182 HOLDEN FC-FE-FB-EK Rear 1/4 Rust Panels - Right $38.00

When I was at Cessnock swap meet, I went to a stall for Betta Auto Rubber, and they said that they made rust repair sections for FB/EK that fit properly, unlike others

freecall 1800674483

or mobile 0407001007

they were from Queensland and didn't have a website set up yet.

Cheers Rob

fb cruisin wrote:When I was at Cessnock swap meet, I went to a stall for Betta Auto Rubber, and they said that they made rust repair sections for FB/EK that fit properly, unlike others

freecall 1800674483

or mobile 0407001007

they were from Queensland and didn't have a website set up yet.

Cheers Rob

Yep, thats jogs my memory, I bought a boot rubber from them at their stall at Cessnock swap and noticed that they carried quite an extensive range of repro parts for our models but I didn't get their contact details , thanks for that Rob .

thanks for those details too Rob and FB1960 will add them to the suppliers list

I dunno if this has been posted anywhere else ...


http://bettaautorubber.com.au

Cheers

I am trying to locate headlight peak rust repair sections for an EK. Rare Spares has advised that itds supplier dosn't make them any more. Can anyone advise where I might get these from? Alteratively where I might get good replacement guards.

Welcome to the forum gandsnewhouse , maybe try placing a wanted ad in the parts wanted section ? Good guards are getting a bit hard to find but someone may be sitting on a pair of the good headlight peaks they will sell.

Thanks will do