Page 1 of 1
Inner door seals
Posted: Sat Feb 06, 2010 7:46 pm
by Laingy
Hi Bit of help required purchased inner door seals from Spectrum Part 805-023 appears rubbers are well short??
Should the rubbers meet i know its hidden under scuff plates but doesnt seam right are they different for utes and sedan doors
Posted: Sat Feb 06, 2010 8:56 pm
by Trev
My wagon is the same
Posted: Sat Feb 06, 2010 9:30 pm
by Laingy
Hi Trev
So do you think this is right then " i got no idea", Didnt want to glue in until know its right. have you had any issues with this not being all the way round door,, given Spectrum is in ST Marys 5 minute drive was going to take back on Monday and request they cut it to the lenght of full door seal if thats what it should be dont want to look like a dill.. Thanks
Posted: Sat Feb 06, 2010 10:06 pm
by Trev
Being under the scuff plates this part is not sealing the opening anyway so I would be leaving it as is, Trev
.
Posted: Sun Feb 07, 2010 7:20 am
by Laingy
Hi Trev and Sunny Tim
Thanks for advice will finish fitting seals today..Weather forcast rain again may aswell spend time in garage.This forum is excellent..once again THANKS
