3.36 Ratio coarse spline diff

Stuart Bowyer · Post by **Stuart Bowyer** » Fri Aug 07, 2009 4:01 pm

Hi all , im chasing a 3.36 coarse spline diff centre for a project if any one can help ?

thanks !

Stuart

yeprat1 · Post by **yeprat1** » Fri Aug 07, 2009 5:32 pm

stuart i will be selling a hr diff with 3.36 center in a month or so when mine gets ripped out complete drum to drum and providing it doesnt get damaged was freshly painted gloss black. cheers troy

Trev · Post by **Trev** » Fri Aug 07, 2009 5:55 pm

Hi Stuart, I have a 3.36 centre but it could cost a bit to send up, prolly (to quote RB

) better to get one closer to home

, Trev

.

mrs ratbox · Post by **mrs ratbox** » Fri Aug 07, 2009 7:23 pm

Trev wrote:Hi Stuart, I have a 3.36 centre but it could cost a bit to send up, prolly (to quote RB ) better to get one closer to home , Trev .

good to see i'm shareing my knowledge of the english language

FB MAD · Post by **FB MAD** » Mon Aug 10, 2009 9:28 am

If it's any help Stuart, I'm taking a trailer to Victoria in about 5 weeks and I'll be dropping in to Trev-ville whist I'm down there and could bring Trev's 3.36 back with me to some where closer to you for pickup if you want.

I'll be travelling back via Junee,Cootamundra,Cowra,Young,Canowindra etc

Cost to you for this pickup transport will be $000,nil,zero,nothing,nought,zilch

Stuart Bowyer · Post by **Stuart Bowyer** » Wed Aug 12, 2009 8:04 am

Thanks guys , got one !