Page 1 of 1
HR front end
Posted: Sun Sep 21, 2008 6:58 pm
by quick finking
Hey i have a EK ute with a HR front end,
i was wondering how i would go about lowering it 2-3 inches.
any help will be appreciated.
Posted: Sun Sep 21, 2008 7:03 pm
by DeadSled
Good to see you made it over here man.
As said on the thread on Boost.. Lowered Springs (King Springs) would be the way to go as with any car for the front.. and lowering blocks or reset leafs for the rear.
Unless you wana go all out.. C notches, bags, four links ect ect..
Posted: Sun Sep 21, 2008 8:01 pm
by mrs ratbox
only thing with springs is you might get 2" i don't think you'll get 3"
pull yor springs out cut 1 1/2 - 1 3/4 coils off should do the trick
Posted: Sun Sep 21, 2008 8:02 pm
by quick finking
is that what you have done?
im kinda looking for the cheapest possible solution
Posted: Sun Sep 21, 2008 8:36 pm
by mrs ratbox
it's not really reckomended
BUT with over 500 cars under my belt most of which were lowered with this method i'm still here to tell the story so can't be that bad
Posted: Sun Sep 21, 2008 8:37 pm
by quick finking
mmmk, it sounds the easiest/cheapest way to go so i will give it a go,
if it fails i will go buy some new king springs as deadsled mentioned before
Posted: Sun Nov 16, 2008 8:07 pm
by hammondo
ratbox wrote:with over 500 cars under my belt
Holy Moly
Posted: Sun Nov 16, 2008 9:59 pm
by mrs ratbox
hammondo WELL over 500
not all built or modified a great deal but most touched in some way by me, very few just bought and drove
Posted: Mon Nov 17, 2008 11:12 am
by Finny
