fbekholden.com

Posted: **Sat Jul 26, 2008 6:21 pm**

Hi
are you able to buy just the end of the sill rust repair sections
front or rear insted of buying a hole sill

from rare spares
or any other repro sellers
if so where from

jay

Posted: **Sat Jul 26, 2008 6:29 pm**

i have a left rear

Posted: **Sat Jul 26, 2008 6:43 pm**

Scott's Old Auto Rubber in Oakleigh, Melbourne used to.
Don't know if they still do

Posted: **Sat Jul 26, 2008 6:44 pm**

I think Scott's have a website

Posted: **Tue Jul 29, 2008 4:33 pm**

checked scotts out no luck

any more sugestions any one

Posted: **Tue Jul 29, 2008 7:20 pm**

Hi Jay,

I was contact recently by the owners of this place...

http://www.retrorodsandrestorations.com.au/

have been meaning to add them to the list of suppliers and services on the Forum but just havnt had time.

They list sills so maybe they might be prepared to do a section...

regards
Stewart

Posted: **Thu Jul 31, 2008 5:03 pm**

ekjay, just bring the oxy torch out to all holden day, i reckon we could score a few good rust sections.

I did look at the retrorod site, prices seemed better than rares.

Posted: **Thu Jul 31, 2008 8:45 pm**

thanks stewart sent them a email today about
postage cost

and Retro might have to bring the cordless grinder
and a box of cutting disks to the AHD