Page 1 of 1

Autometer Gauges in standard instrument panel

Posted: Tue Jun 17, 2008 2:09 pm
by VS355
Hi all,

I was looking for some Information and/or some pictures on putting Autometer or similar gauges into the Standard instrument panel.

Also pics of the finished results.
Any help would be greatly appreciated.


Cheers

Matt :)

Posted: Tue Jul 01, 2008 8:20 pm
by andy
hey buddy,
if u wanna see some pics of autometer gauges have a look at malcoms yellow fb in "share your pics of interior" page 2 looks gr8. custom made tripple gauge pod sitting where your heater instruments normally sits i rekon a 5inch monster would sit nice in there along with water, oil, pressure.

Posted: Tue Jul 01, 2008 10:07 pm
by stinky
I know the Autometer speedos fit the FE/FC dash, all I had to do was make a 12mm MDF ring for a snug fit. Not sure how you'd go with the bezel in the FB/EK dash, why not take a bare dash down to your local Autometer supplier and try it out.