Page 1 of 1
wiper base fitment
Posted: Sun Apr 06, 2008 9:43 pm
by Malcolm
Hey all,
Does anyone have a close up picky they could show me as to how the windscreen wiper base sits in relation to the windscreen mould
Mal
Posted: Mon Apr 07, 2008 9:53 am
by mrs ratbox
are you talking about the D shaped chrome washer/spacer bit?
wiper base fitment
Posted: Mon Apr 07, 2008 1:09 pm
by Malcolm
Yeh thats it
Posted: Mon Apr 07, 2008 7:45 pm
by mrs ratbox
don't have a pic but what is the problem
Posted: Mon Apr 07, 2008 7:56 pm
by Craig
Im uploading a pic at the moment mate
Posted: Mon Apr 07, 2008 7:57 pm
by Craig
hope this helps
Posted: Mon Apr 07, 2008 9:15 pm
by rosco
Hi Malcolm,
from memory, the posts are "keyed" into the holes into the firewall.
Because this mount passes through into the cabin - make sure you fit suitable neoprene/rubber gaskets around those posts......
I believe I used a smearing of butyl-mastic on the firewall side of my gaskets...
frats,
Rosco
wiper base fitment
Posted: Mon Apr 07, 2008 10:23 pm
by Malcolm
Thanks guys,
Mine is the same as the picture but it just doesn't look right. As the mould goes over the top of the wiper block it seams to sit up in that area compared to the rest of the mould along the bottom of the screen.