fbekholden.com

Looking for an OEM engine oil dipstick for a early 60's Chevy 283.

Hi Mr OZ EK.

I may have one but will need to look tomorrow during the day, i will keep you posted.

Greg

EK283 wrote: Sun Mar 24, 2024 7:52 pm Hi Mr OZ EK.

I may have one but will need to look tomorrow during the day, i will keep you posted.

Greg

Thanks!

Mr OZ EK,

Sorry but i do not have one, i do however have the original tube, its a bit battered and has been brazed around the edge that goes into the block.

yours if you want it.
Greg

EK283 wrote: Mon Mar 25, 2024 6:03 pm Mr OZ EK,

Sorry but i do not have one, i do however have the original tube, its a bit battered and has been brazed around the edge that goes into the block.

yours if you want it.

Greg

Greg, thanks for taking the time to have a look, appreciated!....I'm ok for a tube, still have one in the block.

If anyone might have a dipstick the one I need has the flat finger hook, the same as an early 60's Chev, my motor is from a 63 Impala.

I think I still have one from a 68 307-should be the same?


Sent from my iPhone using Tapatalk

ekv8ute wrote: Wed Mar 27, 2024 1:24 am I think I still have one from a 68 307-should be the same?


Sent from my iPhone using Tapatalk

If you can find it I'd be interested for sure.

Learn something every day.....Apparently the colour of the plug / tip denotes the length of the dipsticks that were used in the late 1960's & 70's Chev motors.

I won’t be home until a couple of days after Easter, I’ll let you know then. Cheers Mark


Sent from my iPhone using Tapatalk

ekv8ute wrote: Fri Mar 29, 2024 10:21 pm I won’t be home until a couple of days after Easter, I’ll let you know then. Cheers Mark


Sent from my iPhone using Tapatalk

Sorry mate, I’ve had a good look through my parts stash, can’t find the dip stick


Sent from my iPhone using Tapatalk