Page 1 of 1
wiper shafts
Posted: Mon May 24, 2021 7:59 am
by fraze
The wiper actuating shafts, behind the dashboard, have a nylon/plastic bush at each end. the bushes on my wipers are worn out and i would like to replace them. Has anyone got a fix for this? Thanks, Fraze
Re: wiper shafts
Posted: Sun Jul 31, 2022 3:11 pm
by mr48215
Yes, get a EH wiper brush kit from Rare's. Take out the plastic ball bushings in the kit and you will find the plastic ball brushing will snap into your EK wiper arm and then file down the top ball section of this clip until you can fit your wiper arm holding clip on. Sometimes you have to enlarge the centre hole in the clip so the shaft can fit in. Don't worry if you file the ball down too much just use a shim washer. Lube and no more floppy arms.
Re: wiper shafts
Posted: Sun Jul 31, 2022 6:42 pm
by Errol62
Ripper info Mr.
Sent from my SM-G781B using Tapatalk
Re: wiper shafts
Posted: Mon Aug 01, 2022 9:51 am
by FireKraka
That is great info thanks
Re: wiper shafts
Posted: Mon Aug 01, 2022 10:29 am
by Blacky
Theres a bloke on Facebook who sells FB/EK ones , about $20 a set , I bought a couple of sets off him but havent tried to fit them yet - my ute needs them done.