fbekholden.com

I know a lot of us on here would like a rotisserie rig to make life easy but wonder if it will fit in the shed as far as the height goes. I can most likely find a spot to 'spin' it but the ideal place is near the front of the garage where the panel door is.

Would a few out there with current shells in rotisseries or past experience with them, and the height restrictions post some info for me. I am sure others will be curious too.

I figure if I have to I will design around the height by dropping the base to gain some wriggle room but would prefer avoiding the extra work/time.

Thanks in advance.

Dave Mac

2350mm on the panno
Floor clearance is 250mm

Sedan would be less of course


Sent from my iPhone using Tapatalk

2270 on mine



It is jacked up about 660 off the floor though so I can rotate it around 360 without worrying about hitting any of the cross bracing. I could drop it down about another 400 if I needed but would need to jack it back up if I wanted to rotate it back level. As I am currently flipping it constantly between horizontal and vertical and I have the clearance I just leave it jacked up and only lower it if I am wheeling it anywhere


Sent from my iPhone using Tapatalk

Thanks guys.

I measured 2200 but with some work I reckon I am going to be able to get a away with it.

Keep the figures coming in - this is handy info for lots of us !

Cheers.

Dave Mac