fbekholden.com

Hi there folks,

I'm in the process of fitting an electric wiper motor to my FB.

I'm at the point of connecting the auxiliary drive assembly to the
connector arms.

I was just wondering if there is any advice from people who
have done this before I go drilling grinding and welding it all to fit.

I'm guessing I have to drill out the old auxiliary drive pivot shaft,
shorten it and graft on a bracket to suit the new wiper motor.
See pics for more detail.

Kindly

Dominic



P.S. if someone could take a pic of the coresponding EK shop
manual page showing the electric EK set up I'd be interested
to have a look. Thanks

Original auxiliary drive assembly


New auxiliary drive

dominic
no cutting or grafting or welding
all you need is the other arm that go's off
the small arm on the back of the motor ( pm
sent ) jay