fbekholden.com

0

There was one made for it and this may be a copy. I had a compressed timber one with chrome leading edge on it. Little annoying for passenger but I'm always a driver!!!

if the front lip is an alloy extrusion it may be a genuine one , can you post a photo of it ????

Here it is!

nes138 wrote:There was one made for it and this may be a copy. I had a compressed timber one with chrome leading edge on it. Little annoying for passenger but I'm always a driver!!!

But the passenger will nag me to death and I haven't found the diagram for the James Bond ejector seat....

That looks like an original one - there should be a flat bar strap that fits in the hole , it drops down from under the dash to hold the front of it up.

Don''t have the strap that holds up the front, cant imagine it would be hard to fabricate out of some flat bar. I will sand it back and paint it and then stash it until the time comes to either fit it or not! A bit like the windscreen visor, I cannot decide if I like them or not! If anyone wants to make a copy of it, just send me a message.

i,m leaving the visor off , i,m not that wrapped in the look of them

BIGREVNEV wrote:i,m leaving the visor off , i,m not that wrapped in the look of them

I am not sure, sometimes I see them and think Wow, and other times they make me cringe, just have to see when the time comes!