Page 1 of 4

Shane's EK

Posted: Wed Aug 21, 2013 10:27 pm
by shanek
Just thought I would share a few pics of my "new" EK that I picked up recently, it has a 202 red motor in it and a HR front end, other than that it is pretty standard, not sure where I am going with it yet but it's in the shed so thats a start. These are the pics of eBay.

Image
Image
Image
Image
Image
Image
Image
Image

Re: Shane's EK

Posted: Wed Aug 21, 2013 11:07 pm
by Blacky
Looks good mate, welcome to the forum - what are your plans for her ???

Re: Shane's EK

Posted: Thu Aug 22, 2013 6:46 am
by michaeljohn1234m
Yes welcome to the forum ,if its going ok the have some fun

Re: Shane's EK

Posted: Fri Aug 23, 2013 10:54 pm
by shanek
I have started stripping the car down, the previous owner fixed up a flare job gone wrong by fibre glassing the guards, they looked pretty good but i just had to know what was under there so i had them sand blasted, consequently i am looking for a new set of guards in the Albury Wodonga area, these guards have had repair panels in them and then had time to rust again.

Image
Image
Image
Image
Image

Posted: Sat Aug 24, 2013 8:43 am
by Bluehaze
It's a shame those eyebrow sections had to rust up after so much effort repairing them. Took me ages to tig in my repair section, so much messing around cutting and aligning before carefully welding, checking and welding some more..
Looks like you've got a good project as a starting point. The rebuild journey is long, but worth it.

Re: Shane's EK

Posted: Sat Aug 24, 2013 6:51 pm
by parisian62
Welcome aboard. A lot of us were all in your neck of the woods in June - at Wangaratta for the Nationals...did you check it out?

Stewart

Re: Shane's EK

Posted: Sat Aug 24, 2013 10:35 pm
by MeFB
Definitely a bit of a horror story under the fiberglass, sorry to see that.

I saw your foot in one of the photos, which reminds me, Rise of the Lycans is on TV tonight :lol:

Re: Shane's EK

Posted: Sun Aug 25, 2013 3:18 pm
by shanek
Ok she is all stripped down and ready to go to the sandblasters, excited and scared at the same time. I think I might go and take some notes and make a little template or something so I know where the colour ends and where the black starts, particularly on the dash.

All I need to do now is devise some kind of trolley that will enable me to get it dragged up onto a flat bed to get it to the sandblasters, I would love to hear how others have done this.

Image
Image
Image
Image
Image
Image

Re: Shane's EK

Posted: Sun Aug 25, 2013 5:48 pm
by Trev
Looks real solid, hopefully no surprises after blasting :thumbsup: .

This is how I got the wagon to the blasters, a home made trailer hitch attached to the front and towed on the rear axel.
Image

Re: Shane's EK

Posted: Sun Aug 25, 2013 5:56 pm
by shanek
Thats pretty awesome, I have some 6 inch castors that are good for 100kgs each. I think I might make something up out of 50mm box and somehow bolt it to the bottom. I'll see how it goes.

Re: Shane's EK

Posted: Sun Aug 25, 2013 6:16 pm
by NickZ
is that legal?

Re: Shane's EK

Posted: Sun Aug 25, 2013 6:48 pm
by parisian62
did you check it out?
...I guess not.

Re: Shane's EK

Posted: Sun Aug 25, 2013 8:12 pm
by Devilrod
Love that pick Trev.

Re: Shane's EK

Posted: Sun Aug 25, 2013 8:23 pm
by zl296
camper/car combo... 8)



nice. :clap:

Re: Shane's EK

Posted: Sun Aug 25, 2013 8:51 pm
by Trev
NickZ wrote:is that legal?
Probably not :shh: :shifty:
Devilrod wrote:Love that pick Trev.
Yeh, one of my faves :lol: .