Page 1 of 1

one for the EJ guys?

Posted: Fri Nov 23, 2012 11:39 am
by samprinci
Hi guys, I just wanted to double check. See pic attached.

are the bolts for the top grill assembly (A) the same as the bonnet latch plate bolts (B + C) ? Same colour? are they supposed to be zin plated?

also the bonnet latch plate, are they supposed to be all for bolts? or the rear (C) has screws & the front (B) has bolts same as support bar (A)

Also the bonnet latch cable, is that supposed to be zink plated / colour
pic.jpg
pic.jpg (184.2 KiB) Viewed 530 times
thanks all, look forward to a reply

sam

Re: one for the EJ guys?

Posted: Fri Nov 23, 2012 9:56 pm
by Harv
Sammy,

Tim's right - according to the 20 Beers Master Old Farts Cattledog, B and C should be round head screws, ¼”-28 x ½”.

Cheers,
Harv.

Re: one for the EJ guys?

Posted: Mon Nov 26, 2012 8:53 am
by samprinci
Thanks Tim, thanks Harvey!! much appreciated guys.

Yer I wanted to double check as it has -
2 round head 1/4" phillips screws in C & 2 hex head 1/4" bolts in front

they should be zink plated to yer???
:thumbsup: