Page 1 of 1
Clutch slave cylinder
Posted: Mon Jan 23, 2012 11:17 pm
by John
Hey guys, I need a picture of the clutch slave cylinder return spring on a crash low box. Not sure if the one I'm using is the correct one. Hard to say when it was all just thrown in the boot when I bought her
Re: Clutch slave cylinder
Posted: Tue Jan 24, 2012 8:43 am
by Mai Ki-Ki
Cable clutch set-up...?
Mines an EK and hydraulic.....did FB's have cable..?
M
Re: Clutch slave cylinder
Posted: Tue Jan 24, 2012 1:29 pm
by resto
I looked through a heap of manuals and I can't find a picture of it. It is quite unmistakeable though.
It is about 75 mm long overall with a short section of spring (about 30mm). One end is like a normal spring end, whilst the other has a long extension with a kink in it. The spring only goes on one way as the kink goes around the rubber seal on the slave cylinder.
Resto