fbekholden.com

Hi
I'm in the process of building an Ek sedan. I've put all the panels back on and everything is looking good. All my panel gaps and margins are really good except when i shut the bonnet
i end up on one side where the bonnet bar meets the indicator the bonnet sits out about 5mm past where it should and on the other side in the same spot it sits 3mm short of where its supposed to be. all the other bonnet margins are fine and i've run out of adjustment.
Have i done something wrong?
Am i better off learningto live with because everywhere else is good?
Any advice would be helpfull
Thanks
Dave

thanks i'll give that try
dave

Sounds Like the problem I had with my bonnet I was going to give you a link to it but just checked and photos have been deleted may be mods can help (A MANS GOT TO DO WHAT A MANS GOT TO DO ) But basically I just pushed and pulled till it was right .
BILLY

If photos are missing they might have been moved from where you hosted them, mods won't delete any useful pic's.

May have had something to do with photo bucket, I am not saying they were usefull more that it was a interesting problem.I can PM you photos if yopu want.
BILLY