fbekholden.com

guys im just finding out how hard it is to find wheels for fb's these days the only manufacturers that make wheels to fit cost upward of $600 a wheel and that is just ridiculous i thought i would get some weld wheels seeing that they are only about $300 a wheel but even those only come in hq stud pattern now. so is it possible to interchange the axles on a standard banjo with anything else without costing a fortune. or even a wheel maker that can make steel rims in a 15 complete without me suppling the centers

hope this link works for ya there not my wheels but they look pretty good

http://cgi.ebay.com.au/dragway-pro-whee ... dZViewItem

why not go to HQ or Commodore stud pattern, and with it you'll get better brakes aswell ?

Just run Steelies and thin whites, heaps easier and in 14". Usually found at the tip for free

My set were all roadside and dump finds! Colour code them to the flash or roof and your done, plus you can get the car real low without gaurd lip mods.....

Devilrod wrote:Just run Steelies and thin whites, heaps easier and in 14". Usually found at the tip for free

My set were all roadside and dump finds! Colour code them to the flash or roof and your done, plus you can get the car real low without gaurd lip mods.....

Was it hard to put the lace on them???

you can get centreline wheels in early holden stud pattern, i have a mate that works at rocket industries so if interested let me know. also re the dragway wheels he's just to expensive i bought genuine centreline wheels special ordered for alot less than i could buy dragways for

Nekro63 wrote: Was it hard to put the lace on them???

'ken Oath!!

So subtle you can't see it...... (shakes head)

yeh i think u may have twisted my arm guys i think i wmay still go for 14's though so if anyone in sydney has some 14 inch standard rims let me know and is it still easy to grt the chrome dress rims for them