Page 1 of 1
1/4 vent window
Posted: Sun Apr 18, 2010 10:07 pm
by steve
need to replace 1/4 vent window rubber in the front door, is this a big job, and where is the best place to by them from.
Posted: Mon Apr 19, 2010 7:59 am
by parisian62
not a big job but can be fiddly.
theres a few threads on this.
http://www.fbekholden.com/forum/viewtopic.php?t=438
http://www.fbekholden.com/forum/viewtopic.php?t=3366
you can get the rubbers form rares or spectrum.
some people take the whole 1/4 out and to do this you have to remove all the door guts - glass, winders etc.
or some people make a small cut in the rubber and glue straight in.
if you take the whole 1/4 out be careful not to snap the shaft at the bottom when removing the bolt as its usually rusted in.
Stewart