Page 48 of 106
Re: Project 2.
Posted: Sat Jan 29, 2022 8:28 pm
by ardiesse
I have the same experience as Scott. Makes sense when you consider that the arc is a column of ions, so it'll get bent out of shape by external magnetic fields. I use masking tape instead.
Rob
Re: Project 2.
Posted: Sat Jan 29, 2022 8:39 pm
by Brett027
Maybe it depends on the direction of the magnetism. My little discs are pretty focussed on the end and not much at all on the sides. Anyway, whatever works for your technique is all that counts.
Re: Project 2.
Posted: Sun Jan 30, 2022 12:33 am
by Blacky
Question, why did you not repair that BEFORE you painted it ???????
Re: Project 2.
Posted: Sun Jan 30, 2022 6:48 am
by Brett027
Blacky wrote: Sun Jan 30, 2022 12:33 am
Question, why did you not repair that BEFORE you painted it ???????
There is paint, and there is PAINT
Re: Project 2.
Posted: Sun Jan 30, 2022 11:27 am
by Brett027
Re: Project 2.
Posted: Sun Jan 30, 2022 12:00 pm
by Errol62
:0
FB ute fixer upper, EK van on rotisserie
Re: Project 2.
Posted: Sun Jan 30, 2022 12:57 pm
by Brett027
Little bit done.
Re: Project 2.
Posted: Sun Jan 30, 2022 3:41 pm
by Brett027
Little bit more....
Sent from my SM-T865 using Tapatalk
Re: Project 2.
Posted: Sun Jan 30, 2022 6:52 pm
by Orange Betty
That will buff right out
Dave
Re: Project 2.
Posted: Sun Jan 30, 2022 6:53 pm
by Orange Betty
Orange Betty wrote: Sun Jan 30, 2022 6:52 pm
That will buff right out
Dave
Why didn't my winky dude not work?
Re: Project 2.
Posted: Sun Jan 30, 2022 7:00 pm
by Brett027
There is no kind answer to that question
Re: Project 2.
Posted: Sun Jan 30, 2022 7:05 pm
by Orange Betty
Brett027 wrote: Sun Jan 30, 2022 7:00 pm
There is no kind answer to that question
ha ha, nice one!
Dave
Re: Project 2.
Posted: Sun Jan 30, 2022 8:48 pm
by Errol62
Fark mate
FB ute fixer upper, EK van on rotisserie
Re: Project 2.
Posted: Tue Feb 01, 2022 3:17 pm
by Brett027
Rust converter on yesterdays toil. Rust repairs for tray floor underway. Stirrups yet to be made for floor support, using those little square cut-outs for that job.
Must be 100% humidity- yuk.
Sent from my SM-G975F using Tapatalk
Re: Project 2.
Posted: Thu Feb 03, 2022 12:29 pm
by Brett027
Smoko as I tap this in. Raisin toast and coffee.
Early start today as Cert. Eng. organised to come at 7am this morning to go through a list of things that I wanted clarity/approval on so I could keep going.
He was happy with repairs and brake booster changes and seat adaptors. Couldn't believe how much it had changed since he saw it last.
Today's job is to close in the rear quarter where I have been working the last few days. Progress shown in the attached photos. Should be stitched up by afternoon tea
Sent from my SM-G975F using Tapatalk
