Re: Project 2.
Posted: Fri Jan 28, 2022 10:10 am
funkyscooter wrote: Fri Jan 28, 2022 8:43 am Sure you've probably mentioned it, but what are you priming it with Brett?
Page 47 of 106
Re: Project 2.
Posted: Fri Jan 28, 2022 10:12 am
Acrylic primer today. Scuff up with 3M medium pads and then back to 1k
Re: Project 2.
Posted: Fri Jan 28, 2022 11:19 am
What I am aiming for.
Re: Project 2.
Posted: Fri Jan 28, 2022 11:32 am
FFS - will you slow down ???? You're making the rest of us look like a pack of lounge lizards ..... 
Re: Project 2.
Posted: Fri Jan 28, 2022 1:24 pm
National...Nationals...Nationals
Re: Project 2.
Posted: Fri Jan 28, 2022 1:25 pm
Gunmetal grey Brett?
FB ute fixer upper, EK van on rotisserie
FB ute fixer upper, EK van on rotisserie
Re: Project 2.
Posted: Fri Jan 28, 2022 2:37 pm
No, Electra Blue. Light doesn't show it up in photos.
Re: Project 2.
Posted: Fri Jan 28, 2022 2:39 pm
Blacky wrote: Fri Jan 28, 2022 11:32 am FFS - will you slow down ???? You're making the rest of us look like a pack of lounge lizards .....
Re: Project 2.
Posted: Fri Jan 28, 2022 6:31 pm
The pace is staggering!
Love it and it’s looking good!
Love it and it’s looking good!
Re: Project 2.
Posted: Fri Jan 28, 2022 10:16 pm
Brett027 wrote:No, Electra Blue. Light doesn't show it up in photos.
Sent from my SM-G781B using Tapatalk
Re: Project 2.
Posted: Sat Jan 29, 2022 10:06 am
I'll send you a station wagon Brett if you are bored 
Re: Project 2.
Posted: Sat Jan 29, 2022 10:17 am
Sure, why not? Not bored, but weary.
Re: Project 2.
Posted: Sat Jan 29, 2022 1:56 pm
For those missing rust, here is a little fix. My smallest Project 2 patch. I have been putting this one off for weeks, tossing up silver solder or MIG. Today being a humid stormy day ideal for not much, I bit the bullet and went MIG. You can see that the patch is larger than and inside the hole because it's easier to hold the patch with my little magnets. They are handy bits of kit those magnets.
That is the last rust work forward of the cab wall now complete.
That is the last rust work forward of the cab wall now complete.
Re: Project 2.
Posted: Sat Jan 29, 2022 7:35 pm
Brett, do you have issues with the MIG and magnets? Mine are out of a couple old Hard Disk Drives and the weld goes to sh!t if I get too close to them.
Re: Project 2.
Posted: Sat Jan 29, 2022 8:06 pm
No not really Scott. I get them off as soon as it's tacked securely, but not noticed any affect so far. Pain in the butt with picking up filings though.