fbekholden.com

SO I got a bit done today.

But I possibly took three steps back - I snapped a spade terminal off the starter motor, which is obstructed by the manifolds, exhaust and turbo
I am hoping my auto elec mate can solder a wire on instead so I don't have to rip it all to bits to replace the starter.

I also chopped a fair bit out of the front guards which I think will help with the tyres rubbing around corners. If this is successful, I will lower the front end to its old height

Andrew

Good to see you got your mo-jo back Andrew. I reckon keeping motivated on any project ....car/house etc is the hardest part.
Looks to be plenty of other projects around you, to keep you sidetracked
Keep on it mate

Getting sidetracked is the biggest problem Ben - those pictures don't show the 3 others cars at our unit also looking for attention

More done getting close now!

nice pedal hahaha you need to bend the top bracket (underneath) so the cable is straight otherwise you may have snapping issues when you step on it! consider a spacer inside as well to give you as little more room of the rail

cheers
Nathan

I have the spacer inside. Will bend the bracket

Sent from my GT-I9100 using Tapatalk

Hey mate,

Nice setup however Holley fuel pumps are meant to be mount vertically. I think it is so fuel doesn't accidently run into the electric mount and go boom.

Regards,

Brad

Put in a few hours today.....

looks sweet man!!

aidan...

Nice

Cheers guys. I am going to have it ready to test fire by Sunday

Sent from my GT-I9100 using Tapatalk

More mooneyes and socal on the way

Didn't get to work on the car today - decided to clean the workshop instead. It was getting pretty feral!

I should be able to complete all wiring tomorrow and then see about firing it up.

Sweet as mate let us know how you go... shotgun come cruise time hahaha

cheers
Nathan

Awsome engine setup....

next time we meet I want details.....
heaps of details...

can't wait to hear about how well she goes ....