fbekholden.com

Got a job I have been putting off done this arvo , like most of these jobs it wasn’t all that hard once I got stuck in and had a go

Marked the tunnel and got it fairly close to straight



Trimmed the box I made months ago and zapped it up



Sent from my iPhone using Tapatalk

Test fitted the top bit



Put rivnuts into the top so the outer boot can screw down and drilled holes so it can be riveted down , covered everything with seam sealer and black paint




Sent from my iPhone using Tapatalk

Done !!!



Sent from my iPhone using Tapatalk

Bewdiful.

Sent from my SM-G781B using Tapatalk

Sent from my iPhone using Tapatalk

Nice work mate


Sent from my iPhone using Tapatalk

Got a little bit more done this weekend, made up a set of MSD plug leads , nice kit but a little spendy . Got the blower belt on and found it sat awfully close to the nut in the middle of the alternator so got a longer alternator belt . A bit more wiring sorted and also got the fuel line finished . Cleaned all the crap out of the cabin area and got it ready to put the carpet back in .



Sent from my iPhone using Tapatalk

Busy weekend Blacky! nice work mate some good progress outa the shed, Rattler looking tidy

Cheers,
Harv

Cool mate!


FB ute fixer upper, EK van on rotisserie

Can’t wait to see the rattler running at a club run mate.

FireKraka wrote: Mon Aug 21, 2023 8:34 pm Can’t wait to see the rattler running at a club run mate.

neither can I .............

Got a couple of hours in today , after I gave the Chev some long overdue maintenance- oil change , refix some stainless strips that were hanging off , grease the front end and a few other bits and pieces




Sent from my iPhone using Tapatalk

Then onto the rattler, got the last of the quarter welded on - marked it up and put a 1 mm disc through it to line the donor piece to the original bit


Then tacked them together




Sent from my iPhone using Tapatalk