fbekholden.com

also Blacky any idea what year BT50 it's out of
thanks

Mick wrote: Wed May 11, 2022 10:03 pm also Blacky any idea what year BT50 it's out of
thanks

Around a 2010 mate

[album][/album]

Mick wrote: Wed May 11, 2022 10:03 pm also Blacky any idea what year BT50 it's out of
thanks

Hey Mick the guy from Nambucca with the 2door ek has a Rodeo one in his from memory

EK JAY wrote: Fri May 13, 2022 7:43 pm [album][/album]

Mick wrote: Wed May 11, 2022 10:03 pm also Blacky any idea what year BT50 it's out of
thanks

Hey Mick the guy from Nambucca with the 2door ek has a Rodeo one in his from memory

yeah i've used Rodeo before they just didn't seem to flip forward very much, i could get into the back seat of the other 2 door with it though

thanks Blacky

got one it's nearly in just gotta make some plates and drill some holes

Sweet mate , glad it worked for ya

Very nice Blacky looks comfy- finished centre console looks great too

Blacky wrote: Sun May 22, 2022 10:21 pm Sweet mate , glad it worked for ya

funny it's out of an '05 bravo but is identical

6 hours in the seat today much better than the buckets i had in it

Good to hear mate , I have only done a 30 minute drive in mine so far

6 hours back home today, still just as happy with it

Give us a look ??

Greg

Bump

I scored another BT-50 seat for the rattler so it’s time to make another set of brackets- the one in the ute sits a little high so I wanted to set it as low as I can get it . Originally I was going to do what I did in the ute and chop a set of original seat mounts up I figured I could do it without chopping up the original brackets.
Ute setup -


Started by removing the factory brackets from the stock seat and comparing the two




It needs to sit further back than the ute as well so I started by making a plate the same size as the original and spacing it up with a bit of 25x25 SHS



Sent from my iPhone using Tapatalk

Then bolted it to the seat and made sure it lines up with the marks on the floor where the original ones sat and tacked it together

Tossed it in the car, bolted the back in and set the height at the front


Was going to make a similar arrangement as the factory setup that slid into the saddles bolted to the floor but that was too fiddly so I just cut some plates that picked up the bolt holes and made SHS spacers again - dunno if the engineer will be happy with that but will find out one day if and when I get this thing engineered


Zapped it all together and it works like a bought one


Painted them up and they are hanging in the shed waiting for me to stop buggerising around on the internet and go and install them


Sent from my iPhone using Tapatalk