Page 180 of 303

Re: Clay’s Wedgewood Blue FB Ute

Posted: Sun Feb 07, 2021 9:19 pm
by Errol62
After 000 steel woolImage

Sent from my SM-G973F using Tapatalk


Re: Clay’s Wedgewood Blue FB Ute

Posted: Thu Feb 11, 2021 6:06 pm
by Errol62
Stickers ImageImage

Sent from my SM-G973F using Tapatalk


Re: Clay’s Wedgewood Blue FB Ute

Posted: Thu Feb 11, 2021 7:15 pm
by Brett027
The SA car club one is a beauty. I guess there will be a 'Life's a beach' one soon?
Go Clay🤗

Re: Clay’s Wedgewood Blue FB Ute

Posted: Thu Feb 11, 2021 7:15 pm
by Wrongway Roger
Well done on the club sticker on the rear window. I knew you would have no problems after your build.

Re: Clay’s Wedgewood Blue FB Ute

Posted: Thu Feb 11, 2021 7:32 pm
by Errol62
Was s challenge Roger. Th asnks for th e heads up. Brett it's a nice sticker. Not normally in to stickers. Not life is a beach, maybe old guys rule.

FB ute driver, EK van project


Re: Clay’s Wedgewood Blue FB Ute

Posted: Fri Feb 12, 2021 6:59 am
by Harv
Not a fan of stickers either, though one of the "classic, not plastic" ones would suit.

Cheers,
Harv

Re: Clay’s Wedgewood Blue FB Ute

Posted: Fri Feb 12, 2021 10:31 am
by Blacky
Need this one -

Image


Sent from my iPhone using Tapatalk

Re: Clay’s Wedgewood Blue FB Ute

Posted: Fri Feb 12, 2021 5:29 pm
by Errol62
Yairs!

FB ute driver, EK van project


Re: Clay’s Wedgewood Blue FB Ute

Posted: Fri Feb 12, 2021 7:25 pm
by Errol62
Mucking around on Friday night. Deliberately loading up the rear. Half tonne load estimated. Still got 3" to bump stops and the spring is flat. Front sits 8" to bottom of sill, unladen 8.7". Rear 7.9" laden, 9.7" unless . 1.8" lowered rear.

The 215 65 14 tyres interfere with the guard by a few mm. New rims will be 5mm less offset, and run 205 60 or 195 65 14. Should be able to get it lower still. Just waiting until after Charmaine's "mystery" cruise next weekend, then I'll pull the rear out and replace the springs.ImageImageImage

FB ute driver, EK van project


Re: Clay’s Wedgewood Blue FB Ute

Posted: Sat Feb 13, 2021 4:46 pm
by Errol62
Ute been in the naughty corner since last weekend when the inside drivers door handle popped off outside the bakery how embarasing. After trying different handles and clips, changing cranks and chopping down the spring still no luck.

Re set clip spring in the vice and all sorted!? Next time I'll do that first.

FB ute driver, EK van project


Re: Clay’s Wedgewood Blue FB Ute

Posted: Sat Feb 13, 2021 5:19 pm
by Harv
Errol62 wrote: Sat Feb 13, 2021 4:46 pmRe set clip spring in the vice and all sorted!? Next time I'll do that first.
Some clips seem to be spring steel (like a bulldog clip), others seem to be chrome plated mild steel (as rigid as trifle).

Cheers,
Harv

Re: Clay’s Wedgewood Blue FB Ute

Posted: Sat Feb 13, 2021 7:58 pm
by Errol62
https://www.ebay.com.au/itm/292771293181

FB ute driver, EK van project


Re: Clay’s Wedgewood Blue FB Ute

Posted: Sun Feb 14, 2021 8:56 am
by Patrick_R
Whoops.
That’s a bit embarrassing mate.

Your ute just looks a million bucks mate.
The blue is just sensational.

Re: Clay’s Wedgewood Blue FB Ute

Posted: Sun Feb 14, 2021 2:47 pm
by Errol62
More embarrassment this morning. Went for a run down for a surf rally and ran out of petrol on the way home. Same old story, gauge showing 1/3 tank. Wife came to the rescue but sitting on the side of the road for a half hour.


FB ute fixer upper, EK van on rotisserie

Re: Clay’s Wedgewood Blue FB Ute

Posted: Sun Feb 14, 2021 3:15 pm
by EK283
Easy fix,

Benda da wire !!!!

Greg