Re: Brodie's EK.
Posted: Sun Oct 07, 2012 8:29 pm
Real nice 
.
.Page 13 of 13
Re: Brodie's EK.
Posted: Mon Oct 08, 2012 7:38 pm
Great job mate. Enjoy the cruisin while ya can!
Re: Brodie's EK.
Posted: Sun Apr 24, 2016 11:00 pm
What a great detailed build. Im loven this rig.
Re: Brodie's EK.
Posted: Mon Apr 25, 2016 12:03 am
Nice work mate
Re: Brodie's EK.
Posted: Mon Apr 25, 2016 9:03 am
For a mutton headWesternWagon wrote:Nice work mate
Re: Brodie's EK.
Posted: Thu Jun 01, 2017 8:44 pm
Just posting on here for those of you in Brisbane who may have forgotten this build or Brodie the young fella who is the owner / builder of EKOOL .
He is in Brisbane this weekend with XBOSS at the Qld show in the Brisbane Convention & Exhibition Centre South Bank, If any one wants to catch up with him for a yarn , then head on down to the XBOSS display and say G'day .
Cheers !
He is in Brisbane this weekend with XBOSS at the Qld show in the Brisbane Convention & Exhibition Centre South Bank, If any one wants to catch up with him for a yarn , then head on down to the XBOSS display and say G'day .
Cheers !
Re: Brodie's EK.
Posted: Mon Feb 11, 2019 5:53 pm
Hi Brodie, do you have the measurements for the spacers you spin up for the VE hinges? Keen to do the same conversion
Re: Brodie's EK.
Posted: Sun Feb 24, 2019 3:20 pm
G'day Taz ,
Brodies old man here , I will rattle his cage for you as he is a busy bloke these day's . He used ally stock , cut and milled it to suit . I don't know what the dimension's are but will make sure he get's back to you . The inner gaurd gutter rail does not need to be narrowed as he did , a hot air gun a rubber mallet with gentle caressing will do the trick . It is tight , but keeps it simple .
Regards
Leigh
Brodies old man here , I will rattle his cage for you as he is a busy bloke these day's . He used ally stock , cut and milled it to suit . I don't know what the dimension's are but will make sure he get's back to you . The inner gaurd gutter rail does not need to be narrowed as he did , a hot air gun a rubber mallet with gentle caressing will do the trick . It is tight , but keeps it simple .
Regards
Leigh
Re: Brodie's EK.
Posted: Tue Feb 26, 2019 11:04 pm
Cheers Leigh, yes I saw the drip rail mod etc. Have some hinges so will make a start with modifying them to suit the bonnet. Tell Brodie that I did send him a message via messenger. If he has the measurements for the spacer then good if not it is no big deal.
Thanks again
Thanks again
Re: Brodie's EK.
Posted: Mon Jan 17, 2022 9:29 am
Bump for Gledge - Page 11 mate