Page 2 of 2
Posted: Fri Nov 23, 2007 8:28 pm
by Thommo
I cut mine on a lathe with a hacksaw, while it was spinning,
Then used an angle grinder the same way.
Posted: Fri Nov 23, 2007 10:01 pm
by stinky
If you are taking it through Regency, do not cut the bump stops as they require a minimum bump stop height. They are fairly generous with their bump stop clearance though, last time I checked -
Bump stop min height - 51mm
Bump stop clearance Front - 25mm, Rear 67mm
Posted: Sat Nov 24, 2007 3:54 pm
by basic.green
Hi all. REGENCY not if i can help it. Thanks Stinky for the measurements i will do some measuring soon. do the stops just unbolt.
Posted: Sat Nov 24, 2007 4:21 pm
by Thommo
The stops just pull out.
A little twisting may help.
Posted: Sat Nov 24, 2007 6:21 pm
by stinky
A bit of detergent and water if they are really stubborn
Posted: Sat Nov 24, 2007 8:25 pm
by basic.green
Thanks for you help THOMMO and Stinky