Re: In tank fuel pump
Posted: Mon Nov 20, 2023 2:22 pm
Cheers mate good luck
Ok fuel system wrapped up now just need engine to feed fuel
I hate blue fittings but seemed appropriate as a vent
Sent from my iPhone using Tapatalk
fbekholden.com
FB-EK Holden Car Clubs of Australia
https://www.fbekholden.com/forum/
In tank fuel pump
Page 2 of 3
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 6:54 pm
Ok fuel system wrapped up now just need engine to feed fuel
I hate blue fittings but seemed appropriate as a vent
Sent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 7:11 pm
Sent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 8:46 pm
6" Glen?
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 8:47 pm
Not quite… close as possible
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 9:15 pm
FB ute fixer upper, EK van on rotisserie
Re: In tank fuel pump
Posted: Thu Nov 23, 2023 10:10 pm
Looking great Gledge
Re: In tank fuel pump
Posted: Fri Nov 24, 2023 10:49 am
looks tidy 
whats the latest with the donk ???
whats the latest with the donk ???Re: In tank fuel pump
Posted: Fri Nov 24, 2023 11:47 am
Roller cam set up is sorted but the old cam spat metal on the piston skirts and scored the bores so it’s in getter power Honed .. should get block back late next week.. I just need to check pushrod length and try install offset head dowels to try stop the valves hitting the block
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Fri Nov 24, 2023 4:09 pm
Mine will be getting an 18V power hone....
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
Re: In tank fuel pump
Posted: Sun Dec 24, 2023 3:16 pm
Big push for boxing day cruise… not hopefull but roller can
Sent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Sun Dec 24, 2023 3:18 pm
Roller cam done new rings bearings and 3/8 pushrods.. fingers crossed valve to block problem solved hopefully 
5000 stall converter may make it hard to run in but we will see how it goes
Sent from my iPhone using Tapatalk
5000 stall converter may make it hard to run in but we will see how it goesSent from my iPhone using Tapatalk
Re: In tank fuel pump
Posted: Sun Dec 24, 2023 8:37 pm
To quote Arnie: "Come on! You can do it !"
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
Re: In tank fuel pump
Posted: Mon Dec 25, 2023 9:42 am
how much fiddling around to fit those lifters mate ? Looks like the sideplate bosses have been milled down ??
Re: In tank fuel pump
Posted: Mon Dec 25, 2023 10:35 am
Not too bad really mate just cut the bosses back and fit a bronze gear…
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk