fbekholden.com

Posted: **Tue Apr 21, 2020 4:39 pm**

HEI distributor installed

Posted: **Tue Apr 21, 2020 4:50 pm**

One for Clay: Jim Pollock shaped Swallow Tailed Mini Gun Rip Curl board circa ‘75.

Posted: **Tue Apr 21, 2020 7:24 pm**

Nice. Wish I still had my first board. Was a 1972 Don Burford, heritage green bottom and rails and orange deck.

I’d rather have a HKTG though.

FB ute fixer upper, EK van on rotisserie

Posted: **Fri Jul 31, 2020 6:20 pm**

Posted: **Sat Aug 01, 2020 12:47 am**

Very good original condition by the look

FB ute fixer upper, EK van on rotisserie

Posted: **Sat Aug 01, 2020 10:03 am**

You got the right carby for that filter Patrick?

FB ute fixer upper, EK van on rotisserie

Posted: **Sat Aug 01, 2020 1:16 pm**

No point, getting reefed out for something with a couple more cylinders...

I noticed this looked crap

So some AquaKlean and elbow grease later

Just need to add 2 pots and it’ll be good

Posted: **Sat Aug 01, 2020 2:16 pm**

Column trimatic please

FB ute fixer upper, EK van on rotisserie

Posted: **Sat Aug 01, 2020 2:26 pm**

Column 4L60E

Posted: **Sat Aug 01, 2020 3:50 pm**

HT shift at least. Tunnel mods?

Sent from my SM-G973F using Tapatalk

Posted: **Sat Aug 01, 2020 4:32 pm**

i have three things:

1. Cutting wheel
2. Welder
3. Will

Posted: **Sat Aug 01, 2020 6:06 pm**

gpi wrote: Sat Aug 01, 2020 2:26 pmColumn 4L60E

Then go the CHEV 350,

More power, more fun, less fuss !!!!

Greg

Posted: **Sat Aug 01, 2020 6:23 pm**

a truck motor would do

Posted: **Sun Aug 02, 2020 9:45 am**

V8 TH700R4 SBC bolt pattern to block manual cable kick down no electronic shift like 4L60E and overdrive

Neil's two cents worth.

Posted: **Sun Aug 02, 2020 10:52 am**

.

Sent from my SM-G973F using Tapatalk

Paddy’s HT Holden Belmont ute