Harv's HR Holden Premier wagon

Got something else that you want to show off that's not an FB or EK? Try this section.

Moderators: reidy, Blacky

Mick
Posts: 4264
Joined: Sun Sep 26, 2010 8:47 am
State: NSW
Location: Coffs Harbour NSW

Re: Harv's HR Holden Premier wagon

Post by Mick »

something wrong with you :wink: :lol: worst thing i did was buy another VY SS ute the EK just collects dust in the shed now :roll: :oops: though i'm struggling not to go look at a windowless HR van legal V8 in QLD :twisted: in case it follows me home :problem:
sometimes yor just better off shitting in yor hands and clapping

W.S.C.C.A
Woodstock chapter
User avatar
Harv
Posts: 5453
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Re: Harv's HR Holden Premier wagon

Post by Harv »

Mick wrote: Fri Jan 24, 2020 11:53 pmsomething wrong with you :wink: :lol:
I know :oops: :lol: I got into the Prem on Monday afternoon, after it had been in the sun all day. Made me question how smart it was to get rid of the VS’s air conditioning. Perhaps not the smartest move in central Queensland.

After a week of driving, I’m still fascinated by the flashing handbrake warning light.

Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
gpi
Posts: 1131
Joined: Mon Apr 26, 2010 2:08 pm
State: VIC

Re: Harv's HR Holden Premier wagon

Post by gpi »

just steer clear of city driving with traffic lights where the aircon stops working :thumbsup:
User avatar
Errol62
Posts: 10772
Joined: Sat Dec 06, 2014 2:44 pm
State: SA
Location: Adelaide

Re: Harv's HR Holden Premier wagon

Post by Errol62 »

Harv you need another wee project. You’re good with pulleys n stuff. VK commodore compressor and vintage under dash head. Have fun with it mate.


FB ute fixer upper, EK van on rotisserie
getting my FB ute on the road
EK van on rotisserie
User avatar
Harv
Posts: 5453
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Re: Harv's HR Holden Premier wagon

Post by Harv »

Errol62 wrote: Sat Jan 25, 2020 8:00 am Harv you need another wee project. You’re good with pulleys n stuff. VK commodore compressor and vintage under dash head.
Must resist temptation... must not start another project... must finish the 1000-odd I started...must not go looking for the red motor twin pulley in the shed...

Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
Mick
Posts: 4264
Joined: Sun Sep 26, 2010 8:47 am
State: NSW
Location: Coffs Harbour NSW

Re: Harv's HR Holden Premier wagon

Post by Mick »

yeah as mentioned if you can keep moving it's not to bad without air, mine just comes down to the steering handling and smoothness of acceleration (i think) surprisingly the EK is nicer to drive on bumpy roads i can only put that down to tyre sidewall height
sometimes yor just better off shitting in yor hands and clapping

W.S.C.C.A
Woodstock chapter
User avatar
thebrotherj
Posts: 682
Joined: Wed Aug 21, 2013 4:09 pm
State: NSW
Location: Sydney

Re: Harv's HR Holden Premier wagon

Post by thebrotherj »

Harv wrote: Sat Jan 25, 2020 6:00 am
Mick wrote: Fri Jan 24, 2020 11:53 pmsomething wrong with you :wink: :lol:
I know :oops: :lol: I got into the Prem on Monday afternoon, after it had been in the sun all day. Made me question how smart it was to get rid of the VS’s air conditioning. Perhaps not the smartest move in central Queensland.

After a week of driving, I’m still fascinated by the flashing handbrake warning light.

Cheers,
Harv
Fantastic purchase mate. How great is the flashing handbrake light?! Them globes are getting tricky to find now I bet.

Harv, I'll have a close read of your list again. I've built two HRs and *hopefully* still have a slew of parts at the parents' house, some at my brothers' too. My bros was a Special, mine a Premier with red interior like yours. I'll dig up some photos.

Oh and I still have all your Stromberg tuning bits too! To discuss another time, I'll trundle out to yours to return it all soon promise :)

Cheer! Joe
Blacky
Posts: 13303
Joined: Tue Jul 20, 2004 8:58 am
State: WA
Location: up in the Perth hills

Re: Harv's HR Holden Premier wagon

Post by Blacky »

Found it - that the one you are after ??,ImageImage

Sent from my SM-A705YN using Tapatalk

I started with nothing and still have most of it left.


Foundation member #61 of FB/EK Holden club of W.A.
User avatar
Harv
Posts: 5453
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Re: Harv's HR Holden Premier wagon

Post by Harv »

Its very similar to the one I'm after. That's 7434146, the Trico washer pump for HR. The one I have is 7430911, the Preslite pump for HR. I'm not sure if these two are interchangeable (HR gurus, please chime in?)

In any case, many thanks for digging it out. If WA is as warm as Sydney today, it would have been a three-beer effort (42C here in the shade... and somewhat warmer in the shed :( ).

Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
ardiesse
Posts: 1128
Joined: Thu Jan 19, 2017 9:57 am
State: NSW
Location: Sydney

Re: Harv's HR Holden Premier wagon

Post by ardiesse »

Harv,

You've fallen foul of the two-supplier problem. Trico and Preslite are like Lucas and Bosch. The parts don't interchange. And to make it worse in the wiper motor department, the wiring harnesses and switches are specific to either Preslite or Trico.

Let me take a look in the spare parts department tomorrow (after waving the spider-warding stick).

Rob
Blacky
Posts: 13303
Joined: Tue Jul 20, 2004 8:58 am
State: WA
Location: up in the Perth hills

Re: Harv's HR Holden Premier wagon

Post by Blacky »

Harv wrote:
In any case, many thanks for digging it out. If WA is as warm as Sydney today, it would have been a three-beer effort (42C here in the shade... and somewhat warmer in the shed :( ).

Cheers,
Harv
Only 36 here today mate, but I have 4 house sized evaporative coolers on the shed so it's nice in the shed - just don't go outside ImageImage

Sent from my SM-A705YN using Tapatalk


I started with nothing and still have most of it left.


Foundation member #61 of FB/EK Holden club of W.A.
User avatar
Harv
Posts: 5453
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Re: Harv's HR Holden Premier wagon

Post by Harv »

Thanks gentlemen - appreciated.

Dropped into Rares on Saturday to order the shopping list of missing rubbers... about half a “complete” set.

Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
fb delivery
Posts: 1702
Joined: Sun Apr 25, 2010 10:17 pm
State: NOT ENTERED
Location: Toowoomba

Re: Harv's HR Holden Premier wagon

Post by fb delivery »

Harv
The wiper motor you have is the Premier type with in built washer pump
The plain ones do not have the washer pump on them
i have two Premier ones - they need new tops ,can get on ebay
PM your phone number and i might be abill to send a pic


Rob
ardiesse
Posts: 1128
Joined: Thu Jan 19, 2017 9:57 am
State: NSW
Location: Sydney

Re: Harv's HR Holden Premier wagon

Post by ardiesse »

Harv,

After waving the spider-warding stick, I located two Preslite wiper motors, minus washer pump, and one Trico wiper motor, with washer pump. The Preslite motors will have been left over from when I resurrected my HD Premier's windscreen washers in '85. Maybe, if I search diligently, I can find some of the washer parts.

And an HD/HR washer bottle, and a Casbah Red steering wheel for a Premier, in OK condition.

Rob
User avatar
Harv
Posts: 5453
Joined: Mon Oct 08, 2007 2:00 pm
State: NSW
Location: Sydney, Australia

Re: Harv's HR Holden Premier wagon

Post by Harv »

Many thanks gents.

Qld Rob: I’ll grab a Preslite Premier pump please, and the headers. The price in the PM is OK. Please PM me the best way to get the cash to you. I’ll PM you the contact details for the gentleman in Toowoomba and see if we can organise a pickup.

NSW Rob: many thanks for battling the spooders. Can I please grab the washer bottle (let me know what I owe you), and any washer parts that show up. Suspect I may need to use Robs plus mine to make one good one. My steering wheel is OK, but pretty heavily worn. I’ll take some photos once I am back at work.

Cheers,
Harv
327 Chev EK wagon, original EK ute for Number 1 Daughter, an FB sedan meth monster project and a BB/MD grey motored FED.
Post Reply