Re: FB - EK Side Mould Clip ... Press on
Posted: Tue Oct 18, 2011 8:55 pm
Spectrum ... She didn't get out of her chair ..... Just said we don't have them !
Steve
Steve
wow what great service...! 
fbekholden.com
FB-EK Holden Car Clubs of Australia
https://www.fbekholden.com/forum/
FB - EK Side Mould Clip ... Screw on clip - Press on Strip
Page 2 of 2
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 18, 2011 9:09 pm
wow what great service...! Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 18, 2011 9:17 pm
spectrum aren't all they're cracked up to be but i can tell you also they don't have them been there numerous times all they have is this'll do clips
it sucks tim as i said they'de be quite easy to make just a little costly and i think they could make in one day (after the die was produced about another day) more than would ever be sold
it sucks tim as i said they'de be quite easy to make just a little costly and i think they could make in one day (after the die was produced about another day) more than would ever be sold
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 18, 2011 9:22 pm
The die itself would be costly. I've seen dies for items simpler looking than these clips cost a fair few thousand bucks.
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Sat Oct 22, 2011 8:15 pm
What about Alan McCoy?
Garfield Rd,Riverstone.
Garfield Rd,Riverstone.
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:00 pm
Sam Crupi was making the side trim clips, so give him a try.
Regards Bill
Regards Bill
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:05 pm
That is very exciting to hear Bill .... STeve
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:10 pm
I got some off him for the pink thing and they fitted up pretty good.
Hope Sam can help you out Steve.
Regards Bill
Hope Sam can help you out Steve.
Regards Bill
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:13 pm
Thanks Bill. I will call Sam tomorrow!!!
Steve
Steve
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:17 pm
If he is out of stock Steve, I'm pretty sure Martin still has some that Sam sent down to sell at the club.
Re: FB - EK Side Mould Clip ... Screw on clip - Press on Str
Posted: Tue Oct 25, 2011 10:20 pm
I spoke to Martin a few days ago about a bunch of Mats, didn't think to ask him about those clips ... 
Tomorrow!
Love this forum
Tomorrow!
Love this forum