Posted: Sat May 19, 2007 6:13 pm
sexy 
looks soooo nice!!!
looks soooo nice!!!Page 2 of 2
Posted: Sat May 19, 2007 6:19 pm
Nice work Sam.
Posted: Sat May 19, 2007 7:31 pm
Nice work there Sam, congrats on the baby also,
Trev
.
Trev
.Posted: Sun May 20, 2007 7:55 am
Looking awesome Sam.
And cograts on the new addition to the family...
Cheers
Maiki
And cograts on the new addition to the family...
Cheers
Maiki
Posted: Sun May 20, 2007 11:33 am
Good to see ya get some progress Sam. Certainly looking good with the work you have done. I know how hard it is with young ones, but wait till you have two! 
Posted: Sun May 20, 2007 1:28 pm
Or THREE 
,
Trev .
,Trev
.Posted: Sun May 20, 2007 9:49 pm
i like your work!
is the front floor supports attached to the chassis rails at all ? if so that should make for one strong setup!
is the front floor supports attached to the chassis rails at all ? if so that should make for one strong setup!
Posted: Sun May 20, 2007 10:03 pm
Sammy wrote
, but the engineer likes it and I spose thats all that matters .
Cheers Sam
The 25x50 RHS floor supports are welded to the chassis rails and also to the body. Also the floor member where the subframe attaches is also all new RHS, no longer the pressed sheet steel ones. Where the floor member runs up under the trans tunnel, I made that from four pieces of 3mm sheet steel and welded it all together. Probably gone overboardis the front floor supports attached to the chassis rails at all ?
, but the engineer likes it and I spose thats all that matters .Cheers Sam
Posted: Mon May 21, 2007 10:00 am
good to see yor out doing some work and it looks great
Posted: Tue Jul 17, 2007 10:01 pm
whos your engineer grimbo
cheers fatboy
cheers fatboy
Posted: Wed Jul 18, 2007 7:07 am
I'm using ray spence, he is one of the enginners prefered by the the local rego boys.
He is a decent bloke and is very approachable. He'll also back up his work, eg a mate of mine had a car engineered by him, took it to rego and the inspectors tried to pick on stuff the engineer had passed. Ray was promptly on the phone, tearing the inspector a new arsehole, and then when that didn't work Ray took the car to rego himself.
He's done majority of ACT enginnered cars from Rods right through to spanky cars(the ones that go doof doof).
I don't know whether he is NSW accredited though?
I'll find his card and post his details.
Cheers Sam
He is a decent bloke and is very approachable. He'll also back up his work, eg a mate of mine had a car engineered by him, took it to rego and the inspectors tried to pick on stuff the engineer had passed. Ray was promptly on the phone, tearing the inspector a new arsehole, and then when that didn't work Ray took the car to rego himself.
He's done majority of ACT enginnered cars from Rods right through to spanky cars(the ones that go doof doof).
I don't know whether he is NSW accredited though?
I'll find his card and post his details.
Cheers Sam