Re: Maiki's EK - New Wheels / Grille
Posted: Mon May 09, 2011 6:26 pm
Rims ended up being about a grand, and yes the bullet centres from the NZ guy....great product.
M
M
fbekholden.com
FB-EK Holden Car Clubs of Australia
https://www.fbekholden.com/forum/
Maiki's EK - New Wheels / Grille
Page 2 of 2
Re: Maiki's EK - New Wheels / Grille
Posted: Mon May 09, 2011 8:16 pm
Chromies & old holdens, its tradition
Re: Maiki's EK - New Wheels / Grille
Posted: Wed May 11, 2011 7:34 pm
Nice smooth ride ,love the rims so nice 
Bloody Kiwis can turn shit to clay
Bloody Kiwis can turn shit to clay
Re: Maiki's EK - New Wheels / Grille
Posted: Fri May 13, 2011 5:50 pm
Great looking car, clean and simple. Have loved the paint on this since I first saw it. 
Re: Maiki's EK - New Wheels / Grille
Posted: Tue May 17, 2011 9:53 am
Looks great!
IMHO the overriders are OK but the bonnet bar spoils the flow
IMHO the overriders are OK but the bonnet bar spoils the flow
Re: Maiki's EK - New Wheels / Grille
Posted: Wed May 18, 2011 2:43 pm
Noice and toight.
Re: Maiki's EK - New Wheels / Grille
Posted: Wed May 18, 2011 6:03 pm
Sure does....I got a FB one, but then realised they don't fit to the same profile....short of a custom piece not much I can do.stinky wrote:Looks great!
IMHO the overriders are OK but the bonnet bar spoils the flow
The insert was stripped of colour to at least minimise the stand out factor.
Re: Maiki's EK - New Wheels / Grille
Posted: Sat Aug 27, 2011 10:25 am
Kia ora Mate love your car ,very cool . I just got some bullet caps from Phil Hutty and ran into a bit of trouble . I am running Hq front rotors and steel wheels with a 70mm hole , they fit perfectly in the hole but there is no room for them to go over the hub bit sticking out , did you have any trouble with yours?
Re: Maiki's EK - New Wheels / Grille
Posted: Sat Aug 27, 2011 4:17 pm
Hi,
The stock EK hubs look smaller than your ones....I found the front bullets to be a tight (lightly hammer on) fit....but tried each bullet till I found two that were slightly larger and fit well. Looks like yours is hitting at the base?
The stock EK hubs look smaller than your ones....I found the front bullets to be a tight (lightly hammer on) fit....but tried each bullet till I found two that were slightly larger and fit well. Looks like yours is hitting at the base?